- This is an auto leveling sensor for 3D Printers based on open-source.
- Simple, Smart, High-precision, It could work with any kinds of bed materials, such as glasses, woods, metals, and so on.
- It can be operated in the following conditions:
- One I/O for control (PWM or Software PWM)
- One I/O for Zmin(Z Probe)
- GND and +5V power
- Additional power supply can be needed in case which your board does not supply enough amperage.
- Electronic devices can be damaged or even destroyed if connected to the wrong side polarity. [wrong terminal connect to 5V(+) and GND(-)]
- Install BLTouch as far as it possible from magnetic, motor, fan etc.
- The action as pulling/pushing hard the push-pin can make the BLTouch damaged and less accurate.
- Fix push-pin with locking paint after reassembling or adjusting core.
- Please do not change the position of the hex screw(core).
- Do not separate or deform elastic material attached on the push-pin.
- The action(Pull or push push-pin hard) makes damage and lowers the accuracy of sensor
Reviews
There are no reviews yet.